TechniSat TechniBox VIACAM instruction manual Switching DiSEqC on or off

>Now use the up/down arrow keys to select the entry LNB Settings

>Confirm by pressing the OK key.

The menu LNB Settings will be displayed.

The following selections can be made in this sub-menu:

5.4.1 Switching DiSEqC on or off

DiSEqC (Digital Satellite Equipment Control) is a digital signal that can control the functions of DiSEqC-compatible components via the antenna connection.

If your external installation features DiSEqC components, you should enable the DiSEqC control function:

>When this entry is highlighted, use the OK key to switch the DiSEqC function on or off.

5.4.2 Adjusting the Switching Matrix and LNB Properties

The menu reflects the four switching criteria of the DiSEqC control.

Your receiver is pre-programmed to receive ASTRA broadcasts on switch setting A/A, and EUTELSAT signals on setting B/A of a Multiswitch. Should the switching matrix of your exter- nal receiving unit be set up differently, or should you wish to receive satellite signals other than those mentioned, you can adjust the receiver settings as follows:

>Use the up/down arrow keys to select the DiSEqC switch position (1-4) that you wish to use for allocation to a satellite (e.g. A/B 3 No Satellite), and highlight the appropriate entry.

>Press the OK key to confirm.

A list of several satellites will be displayed, from which you can make your selection.

>Use the up/down arrow keys to select the appropriate satellite.

Pressing the up/down arrow keys will move the marker by one line at a time, up or down, while the left/right arrow keys will take you to the previous or following pages respectively.

Should the satellite you are looking for not be included in the list, please select one of the spare settings, which are marked User 1 to User 15.

16