TechniSat TechniBox VIACAM Increasing LNB voltage, Operation Switching on and off

Models: TechniBox VIACAM

1 46
Download 46 pages 53.06 Kb
Page 18
Image 18

Polarisation

Use the OK key to enter the appropriate polarisation plane (horizontal or vertical) on which the selected programme is broadcast.

Symbol rate

The symbol rate is an indication of the volume of data being transmitted per second. A typi-

cal rate might be 27000, indicating that 27000 symbols per second are being transmitted. Use the numeric key pad to enter the appropriate symbol rate.

FEC Rate

The FEC function adjusts error correction to the requirements of the selected transponder. Use the OK key to enter the appropriate FEC. This can be 1/2, 2/3, 3/4, 5/6, 6/7 or 7/8. If the FEC rate is not known, use the Auto setting.

Signal

This line will indicate the signal strength, provided the details of the transponder have been entered correctly.

Red bar : poor reception, digital reception not possible

Yellow bar: good reception

Green bar: excellent reception

5.4.4 Increasing LNB voltage

In order to cope with greater cable length between the external unit and your receiver, it may be necessary to increase the LNB output voltage by 1 V:

>Use the OK key to select either on or off for the voltage increase of 1 V.

6 Operation

6.1 Switching on and off

>Use the key On/standby on the receiver or on the remote control to switch the receiver on.

>Pressing the same key on the receiver or on the remote control again will switch the receiver off again.

>The receiver is now in standby mode, the display on the receiver will now show the time.

If the time is not shown, this must still be acquired by the receiver. In Germany, it is

sufficient to switch the receiver on, and to select Channel 1 (ARD) of the public servi-

ce broadcast system for the time to be acquired automatically.

In order to disconnect the equipment entirely from the electrical mains, use the mains switch on the back panel of the receiver to switch on or off.

6.2 Programme Selection

6.2.1 Using the Programme up/down keys

>Use the Channel up/down keys either on the receiver front panel or on the remote control to move up or down the list one channel at a time.

6.2.2 Using the Numeric Key Pad

>Use the numeric key pad to enter the desired programme/channel number directly: For example:

1

Programme/channel 1

1, followed by 4

Programme/channel 14

2,followed by 3, followed by 4

Programme/channel 234

18

Page 18
Image 18
TechniSat TechniBox VIACAM instruction manual Increasing LNB voltage, Operation Switching on and off, Programme Selection