1800125996 IS6200 Z1_110X154 25/05/12 11:39 PAGE2

-Do not cut or attempt to extend the steaming hose.

-To prevent the appliance over heating, when you hang clothes on garment hook for removing crease, please assemble the attached garment telescopic pole and extend it to its highest position.

Environmental protection first !

￿Your appliance contains valuable materials which can be re-

covered or recycled.

￿ When disposing of it, take it to a local civic waste collection point.

DESCRIPTION

1.

Steam head

12.

Steam hose connector

2.

Steam head hook

13.

Removable water tank

3.

Built in hanger

14.

ON/OFF pedal

4.

Trouser/dress clips

15.

Transport wheels

5.

Hanger holder

16.

Textile steam hose

6.

Pole locking clips

17.

On/ off light

7.

Electric cord holder

18.

Built in accessories

8.

Electric cord

 

a. Fabric brush

9.

Velcro strip

 

b. Crease attachment

10.

Telescopic pole

 

c. Lint pad

11.Pole fastening screw

GARMENT STEAMER ASSEMBLY

Telescopic pole and hanger assembly

1.Unscrew the pole's fastening screw on the base of the pole. (fig. 1)

2.Hold the pole such that the cord holder is on the left. Check that the 2 pole clips are un- locked. (fig. 2)

3.Insert the pole into the base by pressing downwards until the holes of the pole and base are at the same level, so that you can put the screw back. If the holes are not ali- gned, check that the clips of the pole are well and truly unlocked. (fig. 3)

4.Screw the pole fastening screw back in as far as it will go so that the pole is firmly fixed to the base. (fig. 4)

5.Push the hanger on the top of the pole vertically until you hear a click. (fig. 5)

6.Adjust the pole to its maximum height by sliding it upwards then locking the 2 clips. (fig. 6a, 6b)

7.Install the steam head between the hanger hooks.

Filling the water tank

IMPORTANT: Never use water that contains additives (starch, perfume, aromatic subs- tances, softener, etc) in the steamer. Additives such as these can affect the properties of the steam and lead to the formation of deposits.

•Ensure that the steamer is unplugged. Remove the water tank from the base of the ap- pliance by pulling the handle upwards (fig. 7). Unscrew the tank cap and fill the tank. (fig. 8). Maximum capacity is indicated by the “max” mark.

•The steamer must be used with TAP WATER. If the water in your area is hard, we re- commends that you mix half tap water and half distilled water, which reduces the hardnes. You can also use bottled spring water.

2