Removal and Installation Procedures
TDS 684A, TDS 744A, & TDS 784A Service Manual 6–29
Procedures for Outer-Chassis Modules
You should have completed the Access Procedure before doing any procedure in
this collection. The procedures found here, listed in order presented, follow.
HFan
HA14 D1 Bus and Analog-Power and Digital-Power Cables
HA23 SerPar Board
HA29 Video Trigger Board
HA11 Processor/Display Board
HTop Cover and Board Brackets
HRear-Panel Cables
HA10 Acquisition Board
HRear Chassis
1. Assemble equipment and locate module to be removed: Have handy a
screwdriver with a size T-20 TorxR tip (Items 1 and 3). Locate the fan in the
locator diagram Outer-Chassis Modules, Figure 6–2, page 6–13.
2. Orient the oscilloscope: Set the oscilloscope so its bottom is down on the
work surface and its left side is facing you.
3. Disconnect the fan from processor/display board: Unplug the fan’s power
cable from J20.
4. Remove the fan: Remove the two screws securing the fan to the main
chassis, and lift the fan away from the chassis.
5. Reinstallation: Do in reverse order substeps 3 and 4, reversing the removal
instructions in each substep to reinstall the assembly. See the procedure Rear
Cover and Cabinet (page 6–18) to complete reassembly of the oscilloscope.
1. Assemble equipment and locate modules to be removed: Have handy a
screwdriver with a size T-15 TorxR tip (Items 1 and 2). Find the modules to
be removed in the locator diagram Outer-Chassis Modules, Figure 6–2,
page 6–13.
2. Orient the oscilloscope: Set the oscilloscope so its left side is down on the
work surface and its front is facing you.
3. Remove the D1 bus: Grasp the D1 bus and pull it up from the oscilloscope to
unplug it from its two plug-in connectors. (J28 is the connector on the

Fan

A14 D1 Bus and

Analog-Power and

Digital-Power Cables