User safety summary
Terms in manual: CAUTION | Conditions that can result in damage to the product. |
WARNING | Conditions that can result in personal injury or loss of life. |
Power source: Do not apply more than 250 volts RMS between the supply conductors or between either supply conductor or ground. Use only the specified power cord and connector. Refer to a qualified service technician for changes to the cord or connector.
Operation of product: Avoid electric shock by contacting a qualified service technician to replace fuses inside the product. Do not operate without the covers and panels properly installed. Do not operate in an atmosphere of explosive gases.
Safety instructions: Read all installation instructions carefully before you plug the product into a power source.
Terms on product: CAUTION | A personal injury hazard exists that may not be apparent. For example, a |
| panel may cover the hazardous area. Also applies to a hazard to property |
| including the product itself. |
DANGER | A personal injury hazard exists in the area where you see the sign. |
Care of product: Disconnect the power plug by pulling the plug, not the cord. Disconnect the power plug if the power cord or plug is frayed or otherwise damaged, if you spill anything into the case, if product is exposed to any excess moisture, if product is dropped or damaged, if you suspect that the product needs servicing or repair, and whenever you clean the product.
Ground the product: Plug the
Symbols as marked on product:
DANGER high voltage: | Protective ground (earth) terminal: | Use caution. Refer to the manual(s) |
|
| for information: |
Hot surface on or in the printer. | This product is certified under IEC |
Use caution to avoid personal | 825 as a Class 1 Laser Product: |
injury: |
|
WARNING: If the product loses the ground connection, usage of knobs and controls (and other conductive parts) can cause an electrical shock. Electrical product may be hazardous if misused.
WARNING: For your protection, do not defeat any interlocks.
