Maintenance
TDS3000 Series Service Manual 6–25
Installation. Use this procedure to install the display module into the front chassis
and install the front chassis.
1. Place the front chassis with the display facing you. See Figure 6–13.
2. Push the display module tabs through the chassis holes.
3. Use your thumbs to slide all four display module tabs down as far as
possible to lock the display module in place on the front chassis.
4. Place the oscilloscope face down on a soft surface (such as an anti-static
mat), with the bottom facing you.
5. Route the front-panel cable so that it lies parallel to and along the top edge of
the bezel button flex circuit. Position the black vinyl cable cover so that the
wires are exposed from the front panel connector to just over the edge of the
front panel board.
6. Route the front panel cable through the cable post on the front panel and tuck
part of the cable just under the bottom corner of the front panel board. See
Figure 6–14.
Notch
Front-panel cable Front chassis
Cable post
Figure 6–14: Front-panel cable routing