Tektronix TDS3000 Front Chassis and Display Module

Maintenance
TDS3000 Series Service Manual 6–23
You will need a Torx T-10 screwdriver to remove the front chassis.
Removal. Use this procedure to remove the front chassis and the display module.
1. Place the oscilloscope face down on a soft surface (such as an anti-static
mat), with the bottom facing you.
2. Use the Torx T-10 screwdriver to remove the two screws that secure the
front chassis to the front case. See Figure 6–12.
Screws
T-10 (2)
Front chassis
Front panel assembly
Figure 6–12: Front chassis
3. Lift the front chassis out of the front case. Lifting the left end of the chassis
slightly ahead of the right end helps to clear a slight interference at the right
end of the chassis.
Front Chassis and Display
Module