Teledyne 2002 instruction manual Relay Interface Option Board, Relay Board Specifications, Section

SECTION 7

Relay Interface Option Board

The relay interface board is available as an option for the Model 2002. Additionally, relays may be added to either the Digital option Board (RS-232 or RS-485) or to the Analog option Board (0-10 Volts or 4-20mA). In either case the relays operate independently of the other options. The relay board allows the TTL logic setpoints (High, Low) to directly control two SPDT relays. Whenever the setpoint indicator light in the front panel is lit, the corresponding relay is energized. The relay contacts are rated for a maximum switching current of 250VA (resistive load). Connec- tion to the relay contacts is made via connector mounted through the rear panel of the Model 2002. Screw terminals, on the mating connector, are designed for wire from 28 AWG through 14 AWG.

7.1 Relay Board Specifications

		Each relay board consists of			2 Form C (SPDT) relays with the contacts wired in parallel.
		Max. switching power ---------------------------------------------------------------------						120W, 250VA
						(2A @ 125VAC, 1A @ 250VAC)
		Max. switching voltage --------------------------------------------------------------					220VDC, 250VAC
		Max. switching current ----------------------------------------------------------------------							4A DC, AC
		Max . carrying current -----------------------------------------------------------------------							6A DC, AC
		UL/CSA rating --------------------------------------------------------------------------					1.2A @ 125VAC
							1.2A @ 110VDC
							4.0A @ 30VDC
					Connector for Digital or Analog option,
					or dummy connector if no option	HIGH SETPOINT
					is installed	RELAY CONNECTOR
							3	2		1
											COMMON
								NC
							NO
	LOW SETPOINT
RELAY CONNECTOR
	3	2	1
				COMMON
		NC
	NO				Figure 7.1

Model 2002 page 35