Teledyne C-2000

(Rev.8/04)

E1. Facsimile Calls Using a C-2000 Handset

Sending a Fax

1. Plug fax machine or PC into Handset.

2. If using a fax machine,insert document into the feeder.

3. Take handset off hook and verify dial tone.

NOTE: Some fax machines do not support a dialing capability.

In this case,the call must be dialed from the C-2000 handset.

In some instances, the airborne party may wish to dial a voice call to

the ground fax machine’s number prior to sending the fax. To switch

the voice mode call to fax mode,press “+”(Put Call on Hold) fol-

lowed by “3”(Fax) after the conversation is completed.

4. Establish a fax mode call by pressing “3”(Fax) on either the C-2000

handset, the PC, or the fax machine.

NOTE: It is not necessary to press “3” (Fax) if this C-2000 handset has been

conﬁgured as a Fax Station (See Section VI,B5). If the handset has been

conﬁgured as a PC station,the “3” (Fax) does not have to be entered

at the handset,but it must be entered from the PC or fax machine. The

C-2000 system uses the “3”(Fax) to distinguish a fax call from a data call.

5. On the fax machine or PC enter phone # and press “Start/Transmit.”

6. After the fax call is connected,the handset may be placed in its

holder.

7. At the completion of the call,press “End Call”to terminate the

connection.

NOTE1: The airborne fax machine should be conﬁgured with its redial function off.

NOTE 2: As an alternative, the RJ-11 cord may be connected to a remote RJ-11

jack if one is provided for that handset.