Using the Telular Device Manager
Power Up the SX7
1.With the Ethernet cable connected to both your computer and the SX7, ensure that your SX7 is off, and power up your computer.
2.Slide the Power Switch from right to left to power up your SX7.
3.Wait a few minutes for the SX7 to initialize. Once the signal strength LEDs are illuminated, you are ready to proceed.
Power Switch
Signal Strength LEDs
Note
If your computer is configured with a preset IP address, you may need to adjust your network settings to automatically retrieve an IP adddress from the SX7.See “ConfiguringTCP/IP Settings” on page 38.
Wi PATHTM SX7 | 6 | User Guide |
