Telular SX3i How to Set the Post-Receiver Off-Hook ROH Option, How to Set the Pulse Dial Option

Technician Programming Commands – Continued

How to Set the Post-Receiver Off-Hook (ROH) Option

Use the following key sequence to set the post-ROH option:

Press: Φ# * 9 * <Post-ROH option> #

The < > brackets represent the 1-digitpost-ROH option: enter: Φ0 for continuous ROH tone

enter: Φ 1 to turn off ROH tone and periodically check for an on-hook condition.

You must enter either 0 or 1, otherwise the FWT will not update or store this value and the existing stored parameter will remain. The factory default setting is 1.

How to Set the Pulse Dial Option

Use the following key sequence to set the Pulse Dial option:

Press: Φ # * 12 * <Pulse Dial option> #

The < > brackets represent the 1-digitPulse Dial option: enter: Φ 0 to disable pulse dialing capability enter: Φ 1 to enable pulse dialing capability.

You must enter either 0 or 1, otherwise the FWT will not update or store this value; the existing factory default setting is 1.

How to Initiate a Ring-Back Request

Use the following key sequence to initiate an immediate Ring Back: Press: Φ # * 13 * #

There is no Ring Back value to be entered; the command activates when the phone is placed on-hook.

How to Restore the Factory Default Settings

Use the following key sequence to restore the factory default settings: Press:Φ# * 15 * #

There is no Restore Defaults value to be entered; the command acti- vates immediately. If you enter a value, it will be invalid and the FWT will not restore the factory defaults. Note: NAM (Phone Number Setup) data is not affected by this command and will not be changed.

How to Enable/Disable the Zero Dial Delay Option

Use the following key sequence to set the Zero Dial Delay option:

Press: Φ# * 21 * <Zero Dial Delay option> #

The < > brackets represent the 1-digitZero Dial Delay option: enter: Φ0 to disable Zero Dial Delay option

enter: Φ1 to enable Zero Dial Delay option

You must enter either 0 or 1, otherwise the FWT will not update or store this value; the existing stored parameter will remain. The factory default setting is 1.

PHONECELL SX3i AMPS 26 USER MANUAL 12/08/99