Telular SX3i user manual Battery Installation, Installation is complete, Power, DC Port, AC Port

Battery Installation – Continued

7)Connect the batteries as follows:

·Connect one end of the BLUE wire (attached to the battery cover) to the BLACK (-) terminal of the second battery

·Attach the other end of the BLUE wire to the RED (+) terminal of the first battery – as shown in Fig. 9

·Connect the BLACK wire to the unattached BLACK (-) terminal of the first battery

·Attach the RED wire to the unat- tached RED (+) terminal

of the second battery.

8)Carefully lower the batteries into the compartment as a pair, ensuring that the wires are not pinched against the compartment wall

or guides.

9)Once the batteries lay flat,

replace the battery compartment cover and slide the cover closed until the securing tab pops up. Battery

Installation is complete.

10)Re-connect the AC line cord from the power port on the front of your Phonecell SX3i to the power source – see Figure 10.

OR if an external DC power source is used, re-connect the optional DC input cable to the DC Input port.

11)Turn ON the Power switch. After approximately 10 seconds, the LED indicator on the front of the Phonecell should turn RED, then GREEN.

NOTE: the FWT must be connected to AC power for at least 24 hours to fully charge the batteries before they’ll back up your Phonecell SX3i.

	RED
BLACK		Fig. 9

BLUE

Fig. 10

Power	LED
	Indicator
Switch
	DC Port
AC Port

l	AC Power
l

PHONECELL SX3i AMPS 13 USER MANUAL 12/08/99