SpectraLink Corporation

T1 Remote Module Installation

 

Link WTS – Link 3000 MCU

Do not install cards until power is connected.

4.3Connect Power to Shelves

SpectraLink recommends that a licensed electrician install the –48V DC power supply and connect power to the shelves.

See Link WTS – Link 3000 MCU: Installation, Connect Power to Shelves, for more information.

4.4Install Cards

The shelf diagram below shows a fully loaded Expansion Shelf. Any type of Interface Module can be installed in slots 3-12.

Cards contain components that may be damaged by electrostatic discharge. Before handling any of the cards, the installer must attach the grounding strap (included in the Administration Kit) to his or her wrist, and attach the other end of the strap to ground. Only handle the cards by their edges. Do not touch connector contact areas, do not lift cards by any of the components, and do not lay cards down on their component sides. When laying a card down, place it component side up on top of the anti-static bag in which it was shipped.

Install T1 Remote Module

1.Slide the T1 Remote Module into Slot 1 of the Expansion Shelf, until the card clicks into place. Tighten the screws at the top and bottom of the card to secure it.

Install Expansion Shelf Controllers (CSC300)

2.Slide the Expansion Shelf Controller Card into Slot 2 of each shelf (2-20), until the card clicks into place. Tighten the screws at the top and bottom of the card to secure it.

3.Slide the Interface Modules into Slots 3-12 of each shelf (2-20) until the card clicks into place.

Install Interface Modules (CPx316)

4.Slide the first Interface Module into Slot 3 of the Primary Shelf, until the card clicks into place. Tighten the screws at the top and bottom of the card to secure it.

5.Slide additional Interface Modules into their slots. Slots can be left empty if desired.

The following diagram shows a sample fully loaded Remote Expansion Shelf.

Part Number: 72-0059-06-E.doc

Page 18

Page 18
Image 18
Texas Instruments 3000 MCU manual Connect Power to Shelves, Install Cards