Thermador CIT304GB, CIT304GM manual TooVerify

Visual indication	Fault	Measure
F0	The cooking	sensor isLower the cooking sensor. When the visual
	defective.	indication disappears, you can cook again
		without	the cooking sensor.
		Contact	technical service.

F2

F3

F4

The	element	is	too	hotRemove the pans from the elementsF2 .
and	has turned		off.		disappears when you press the display if the
					element has cooled sufficiently. Wait a few
					minutes until the elements have cooled down
					slightly. IfF2 appears again after the element is
					turned	back on, the cooktop				is still too hot.
					off the elements and allow them to cool furth
The	cooking	sensor		isRemove the pan and press the cooking senso
too hot.					Press any symbol on the cooktopF3. The
					indicator disappears if the cooking sensor has
					cooled	enough.
The pot or pan is				tooVerify		that the pot	or	pan	is	properly position
close	to the	control			on the element.
panel.					Verify	that nothing	hot	is	on	the control touch
					panel.

F8		The	element has		beenThe	automatic shut		off was activated.
		in constant		operation, To		continue	cooking,	press	any symbol.
		at high power, for too
		long.
Note:	A gap	may form between the countertop					and the cooktop. For this reason,
	flexible seal all the way around the cooktop. Due							to the characteristics of
	material, there can be irregularities in the						glass ceramic		surface.	Because	of
	mirror-smooth surface of the cooktop, it						is possible for		even the	smallest	o
	bubbles,	less	than	1mm	in diameter, to		be visible. They are not detrimenta
	the functionality or			the durability of the glass ceramic cooking surface.

28