OPERATION
Once detergent has been added and before closing the door of the dishwasher check the wash arms to ensure that they are free to move.With the detergent in the dishwasher and arms free to move:
IMMEDIATE START
•Close the door of the dishwasher making sure that door latches closed.
•Depress the on/off switch. The indicator light for the cycle that was last selected will become illuminated.
•Depress the button for the cycle you desireTWOTIMES if different than the illuminated cycle.
•The dishwasher will start automatically and continue to the end of the selected cycle.
•At the end of the cycle the dishwasher will stop and the display will point to “END”.
NOTE: Your dishwasher (except DW244) features a new sophisticated sensor technology package, which is designed to constantly scan and measure the conditions inside the appliance.
DELAYED START (except DW244)
The start of the washing cycle can be delayed for up to 9 hours, in 1 hour increments.
•Close the door of the dishwasher making sure that door latches closed.
•Depress the on/off switch.The indicator light for the cycle that was last selected will become illuminated to indicate the dishwasher is on.
•Immediately press the timer button labeled CYCLE DELAY - HOURS. The alphanumeric display will change to “1”.
•Press the CYCLE DELAY - HOURS button as many times as necessary until the alphanumeric display shows the number of hours delay desired.
Note: The cycle may be changed at any time during the delay time until the cycle starts.
•The dishwasher will not start until the indicated delay has past.
•At the end of the cycle the dishwasher will stop and the display will point to “END”.
TO INTERRUPT OR RESET CYCLE
(except DW244)
To interrupt cycle simply depress the on/off button to stop operation. If you are interrupting the cycle during a wash or rinse cycle please wait until the water noises stop before opening the door. After opening the door leave it ajar for a few minutes.The cycle then may be resumed by closing the door and depressing the on/off button.
As a safety feature the dishwasher will automatically turn itself off whenever the door is unlatched. However, if the door is opened quickly while in a wash or rinse cycle some water may splash out of the dishwasher. For this reason it is recommended that the machine always be switched to off before opening the door.
If you wish to reset the cycle to its beginning after stopping the dishwasher:
1.Close the door of the dishwasher. Make sure that the door is completely closed and latched.
2.Depress the on/off button, then depress HEAVY WASH button and LIGHTWASH buttons at the same time and hold for approximately 3 seconds.You will see the cycle status bar progress to end. When the drain pump has stopped and the alphanumeric display is at the end the cycle is complete and the dishwasher is reset.
3.Depress the on/off button to
4.The dishwasher is now ready to run your selected wash cycle. Depress the on/off button to restart the dishwasher.
Note: If you wish to change the cycle selection simply depress the button of the cycle desired twice.The light above the cycle will then become illuminated to show it has been selected.
SOIL SENSOR (except DW244)
The Soil Sensor automatically scans the amount of food and fat particles in the water to check how clean or soiled it is. A fresh water refill occurs when needed, but only adds up to a maximum of 7.1 gallons. Soil Sensor will reduce the overall water consumption by about 20% in cases of lightly soiled dishes.
13
