Thermador PHH36DS, PHH30DS manual Discharge Direction

2.Discharge Direction:

The hood is shipped ready for vertical discharge.

WARNING!

Before installing remove the knock-out plate that close the air outlet on the top if is desired to use the range hood for vertical discharge OR the rear outlet if is desired to use the range hood for horizontal discharge. (see also Figure 5).

WARNING!

Once the Knock out plate has been removed, this cannot be reinstalled anymore close the air outlet (see also Figure 5).

To change to horizontal discharge, do the following (see also Figure 4):

a.Remove knock-out plate on the rear side of the hood (see also Figure 5)

b.Remove and keep the 4 screws (2 per side) that fix blower on top of the hood and release it from keyholes.

c.Rotate the blower 90° and check that pins on side blower fixing brackets fit into the pre- installing holes .

d.Fix the blower on the rear side with the same 4 screws (see step b).

3.Assembly of the 8” Transition:

The transition supplied with the hood mounts to the top or rear of the hood.

Note- Cabinet installation with vertical discharge ONLY: do not install transition until hood has been fixed on cabinet.

a.Place the transition piece over the hood exhaust and secure with 4 screws provided (Figure 5).

b.Duct tape connection between transition and hood.

c.Remove tape holding damper.

Keyhole

Pin

Pin

Figure 4

Vertical discharge - knock-out

Horizontal discharge - knock-out

Transition

Vertical

discharge

Figure 5

Transition

Horizontal

discharge

9