Section One: General Safety Instructions
SAFETY
ELECTRICAL REQUIREMENTS AND GROUNDING INSTRUCTIONS
PLEASE READ CAREFULLY
MODELS: GGS30/36/365, GGSCV30/36/365, SGS30, GGN30/36/365 GGNCV30/36/365 & SGN30
Rated 120 volt, 60 Hz., 1.0 Amp.
.
MODELS: SGS36G, SGSCV36G SGN36G & SGNCV36G
Rated 120 volt, 60 Hz., 11.7 Amp
See Installation Instructions for electrical requirements and grounding instructions.
DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE THIRD (GROUND) PRONG FROM THE POWER CORD PLUG.
If the electrical outlet you intend to use does not accept the
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.
ALWAYS DISCONNECT THE ELECTRICAL PLUG FROM THE WALL RECEPTACLE BEFORE SERVICING THIS UNIT.
The power cord on your cooktop is equipped with a three prong grounding plug with polarized parallel blades. This type of plug is for your protection against shock hazard. This cord must be plugged directly into a properly grounded
Cooktop
Cook'n'Vent (optional)
➛ | ➛ | |
| ||
Three | Outlet | |
Prong | ||
| ||
Plug |
|
CAUTION - ALL MODELS
IN CASE OF AN ELECTRICAL FAILURE
If for any reason a gas control knob is turned ON and there is no electric power to operate the electronic igniter of the cooktop, turn OFF the gas control knob and wait 5 minutes for the gas to dissipate before lighting the burner manually. On the models with the ExtraLow™ Gas the two left burners cannot be turned on manually.
To light the burners, carefully hold a lighted match to the burner ports and turn the gas control knob to HI. During a power failure you can use the cooktop burners, but each must be lit with a match.
Page 3