T6000 Saber Assembly Section 2-16
ASSEMBLY
SABER HOSE ROUTING
WARNING NOTE: The sudden release of hydraulic pressure could cause the
sudden movement of very heavy parts. Anyone in the way of these parts could be
severely hurt or killed. DO NOT ALLOW these hydraulic hoses to BREAK or BURST
in order to prevent hydraulic failure Make sure the hoses do not pinch or stretch as
boom moves. Measure TWICE, check TWICE then proceed with caution.
Connect the hoses to the preformed tubes and move the boom arm to the far-
thest forward position. Arrange the hoses in the clamp as shown in the illustration
above, with the 1” motor hoses to the outside, and loosely connect to the swivel.
Next, make sure there is enough slack for all hoses to pivot at the joint where the
main boom arm bends in the swivel and tighten the hoses in the clamp.