Tiger T6000 9.TRANSPORTING THE TRACTOR AND IMPLEMENT

OPERATION

Saber Operation Section 3-36

OPERATION

To un-stow the boom from the boom rest, proceed as follows. Extend secondary boom “OUT” and move main

boom “UP” off of horizontal support. Swivel boom “FORWARD” perpendicular to tractor and switch travel lock

to “OFF” (ONLY FOR DANFOSS SWITCH). The head and booms are now ready for full operation.

When transporting between job sites, the following

procedure should be followed:

• Idle the tractor engine and bring it down to

speed.

• Shut off the power to the cutting head and

allow all motion to come to a complete stop.

• Roll the mower deck all the way back until it is

adjacent to the secondary boom.

• Extend the secondary boom out to clear the

boom rest.

• Swivel the boom until close to the boom rest,

then position the main boom just above the

horizontal boom support of the boom rest.

• Slowly and carefully swivel the boom “AFT”

until the main boom contacts the vertical pad.

• Lower the main boom until it contacts the

upper pad, now the secondary boom can be

lowered to contact the pad on the boom rest.

• Place the “Travel Lock” switch on the main

control switch box to the “ON” position.

• Lastly, turn the joystick master control switch

• to the “OFF” position.The unit is now ready for

self transportation.

9.TRANSPORTING THE TRACTOR AND IMPLEMENT

Inherent hazards of operating the tractor and implement and the possibility of accidents are not left behind

when you finish working in an area. Therefore, the operator must employ good judgement and safe operation

practices when transporting the tractor and implement between locations. By using good judgement and

following safe transport procedures, the possibility of accidents while moving between locations can be

substantially minimized. OPS-U- 0017