Assembly Section 5-4
EGRESS OPERATION
When operating the egress system to lift the deck, turn the key to the “DRAFT”
position and push the rocker switch to the “LIFT” position and it will lift the draft beam.
Once the draft beam is lifted to the highest position, then turn the key to the “DECK”
position and push the rocker switch to the “LIFT” position, and that will raise the deck up
to the travel lock. To seat the deck into the travel lock turn the key back to the “DRAFT”
position and push the rocker switch to the “LOWER” position, until the deck is fully
seated into the travel lock. Turn the key to the “OFF” position and remove the key. To
lower the deck in sert key and reverse the steps that were done to raise the deck.
CAUTION: Never leave the key in the egress switch box. Field
conditions can shake the key out of the switch box and become lost.
Also personal injury or death can occur from sudden dropping or
inadvertent operation of the controls. Make certain the area is clear
before lowering or raising the deck.