OPERATION
12. MOWER STORAGE
It is recommended that the mower be stored with the center section and both wings fully lowered to ground level. If the mower is stored with the wings in the raised position, select a level area and install wing transport lock pins to prevent the wings from falling BEFORE disconnecting the mower hitch and hydraulic hoses from the tractor. Store the mower with the center section transport lock pin installed or with the mower fully lowered. Never store the mower with the center section or a raised wing supported by hydraulic pressure.
Properly preparing and storing the mower at the end of the season is critical to maintaining its appearance and to help ensure years of dependable service. The following are suggested storage procedures:
1.Thoroughly clean all debris off the mower to prevent damage from rotting grass and standing water.
2.Lubricate all mower grease points and fill gearbox oil levels as detailed in the maintenance section.
3.Tighten all bolts and pins to the recommended torque.
4.Check the mower for worn and damaged parts. Perform repairs and make replacements immediately so that the mower will be ready for use at the start of the next season.
5.Store the mower in a clean, dry place with the mower housing resting securely on blocks or at ground level.
6.Keep the driveline yoke from sitting in water, dirt and other contaminants.
7.Use spray
DANGER! Never allow children to play on or around the Tractor and Implement. Children can slip or fall off the Equipment and be injured or killed. Children can cause the Implement to shift or fall crushing themselves and others.
It is critical that driveline clutches slip when an obstacle or heavy load is encountered to avoid mower and/ or tractor damage. If the mower sits outside for an extended period of time or is exposed to rain and/or humid air, the clutch lining plates must be inspected to ensure they are not frozen together from rust or corrosion. If the mower has been exposed to such conditions, at the start of each mowing season, and any time it is suspected that the slip clutch plates may be frozen together, readjust the slip clutch as explained in the maintenance section of this manual
Operation Section |
© 2004 Alamo Group Inc.
OPERATION
