ASSEMBLY
ASSEMBLY
Center Wheel Standard Spacer Plates
On the center section, spacer plates are required between the cylinder lug and its mount plate. The spacer plates allow the transport and cut heights to remain consistent between tire sizes and or blade configurations. Spacers are be preset at the factory, however if blade type or tire type change, so may the spacers. Consult the following chart:
Driveline Shield Chains
Attach CV shield chain to tractor or cutter hitch allowing sufficient slack for turning.
IMPORTANT: OSHA, ASAE, and SAE standards require that all rotating shafts be guarded against contact. The unchained plastic shields can rotate with the driveline but must stop when they contact another object, (Note: these shields may also be chained.)
The shields must be regularly greased and checked that they rotate freely on the driveline. Refer to the Lubrication section for greasing intervals.
Laminated Tires
To reduce the possibility of the laminations separating, the laminated tires should be installed with the laminations oriented as shown.
Adjustable Skids
When installing the material distribution kit, the adjustable skids on the center frame and the wing frames should be set in the lowest positions.
Assembly Section | |
© 2004 Alamo Group Inc. |
|