Grizzly G0664 owner manual Wheel Brush, To adjust/replace the wheel brush

Wheel Brush

The Model G0664 is equipped with a wire wheel brush to clean metal chips from the blade, reduc- ing wear to the blade and machine. With use, the wheel will wear requiring adjustment and eventual replacement.

To adjust/replace the wheel brush:

1.Raise the bow to the upmost position to allow the best access to the wheel brush.

2.DISCONNECT BANDSAW FROM POWER!

3.Support the wheel brush so it doesn't fall, then loosen the two Phillip head screws that secure the wheel brush (Figure 55).

Phillip Head Screws

Wheel Brush

Figure 55. Wheel brush.

4.Adjust the brush so that the blade extends approximately 1⁄8" into the brush bristles.

—If the brush cannot be adjusted to this spec- ification due to wear, it must be replaced. Remove the old wheel brush and position a new one as outlined in Step 4.

5.Tighten the Phillip head screws to secure the wheel brush.

-48- G0664 Heavy Duty Metal-Cutting Bandsaw