Grizzly G0664 owner manual Cutting Angle, To set the cutting angle between 0

Cutting Angle

Your bandsaw has a locking turret with a range of -45° to 60°.

To set the cutting angle between 0° and 60°:

1.Raise the bow high enough to clear the vise and press the emergency stop button to pre- vent accidental startup.

2.Loosen the saw angle lock lever, rotate the saw bow to the desired angle, as indicated by the scale, then re-tighten the swivel lock lever (Figure 24).

Scale

Saw Angle Lock Lever

Figure 24. Saw angle lock lever.

To set the cutting angle between 0° and -45°:

1.Raise the bow high enough to clear the vise and press the emergency stop button to pre- vent accidental startup.

2.Loosen the saw angle lock lever, and rotate the bow to approximately 45°.

-26-

3.Locate the 0° stop bracket and swivel it out of the way, as shown in Figure 25. This will allow the bow to rotate past 0°.

0° Stop Bracket

Figure 25. 0° stop bracket.

4.Loosen the vise position lock lever and slide the vise assembly to the right side of the saw table (Figure 26).

Vise Position Lock Lever

Figure 26. Positioning Vise.

5.Rotate the saw bow to the desired angle, as indicated by the scale, then re-tighten the swivel lock lever. Make sure the vise is clear of the path of the saw before proceeding.

G0664 Heavy Duty Metal-Cutting Bandsaw