Test Run
Once the assembly is complete, test run your machine to make sure it runs properly and is ready for regular operation.
The test run consists of verifying the following: 1) The motor powers up and runs correctly, 2) the stop button safety feature works correctly, and 3) the motor turns the correct direction (machine is not wired out of phase).
If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review Troubleshooting on Page 43.
If you still cannot remedy a problem, contact our Tech Support at (570)
Refer to the diagram below during the test run procedure.
HI6C97N |
|
|
|
|
|
A | B |
| C | D |
|
HI6GI | 11> |
|
|
|
|
E | F |
| G | H |
|
I |
|
|
| K |
|
| D;; |
|
| M | |
ADL | =><= |
|
|
| |
|
|
| HIDE |
|
|
|
| J |
|
|
|
|
| % | L |
|
|
| & | . |
|
| |
|
|
|
| ||
| ' |
| - |
|
|
| ( |
| , |
|
|
| ) | * | + |
|
|
|
|
|
|
| |
Figure 18. Control panel. |
|
| |||
Before starting the saw, make sure you have performed the preceding assembly and adjustment instructions, and you have read through the rest of the manual and are familiar with the various functions and safety features on this machine. Failure to follow this warning could result in serious personal injury or even death!
To test run the machine:
1.Make sure you understand the safety instruc- tions at the beginning of the manual and the machine is setup properly.
2.Make sure all tools and objects used during setup are cleared away from the machine.
3.Make sure that you verify the Required Adjustments listed on Page PB.
4.Fill the cutting fluid reservoir with cutting fluid (Page 30) if you have not already. DO NOT run the pump without cutting fluid or you will damage it.
5. Connect the machine to the power source.
6.Push the safety STOP button (
HIDE , K) in, then twist it clockwise so it pops out. When the STOP button pops out, the switch is reset and ready for operation (see Figure 19).
7)3 | 4 |
4 |
34/0 "UTTON
Figure 19. Resetting the switch.
G0664 Heavy Duty |
