Timex 193-095000-04 manual Alarm, Water & Shock Resistance, POD Informational and Error Messages

ALARM

Up to three alarms may be set to remind you of upcoming events.

1.Press MODE until ALARM appears.

2.Press START/SPLIT to select alarm 1, 2, or 3.

3.Press SET to set selected alarm.

4.Hour digits flash. Press + / – to change hour.

5.Press NEXT and + / – to set minutes, AM or PM (if primary time display is in 12-hour format), DAILY, WEEK- DAYS, WEEKENDS, or day of the week (weekly alarm).

6.Press DONE to confirm and exit.

7.Press STOP/RESET to turn Alarm ON or OFF.

TIPS:

•When Alarm is on, d appears in Time display.

•When Alarm sounds, INDIGLO® night-light and alarm icon flash and alert sounds. Press any button to silence.

•If no button is pushed, alert will cease after 20 seconds and Backup Alarm will activate after 5 minutes.

POD INFORMATIONAL AND ERROR MESSAGES

Blinking antenna icon v – The watch is currently searching for the POD when the wave is blinking. Make sure the POD is on and within range of the watch.

Steady antenna icon V– The watch and the POD are com- municating

Steady jogger icon o – There is no movement detected

Moving jogger icon n– Movement has been detected by the POD and the data is being transmitted to the watch

NO POD DATA – The POD signal was lost. Make sure the POD is powered on and within range. The watch automati- cally powers off after 16 hours of continuous use. At that point, the watch receiver must be turned on again by pressing ON/OFF.

INDIGLO® NIGHT-LIGHT / NIGHT-MODE®FEATURE

1.Press INDIGLO® button to activate night-light. INDIGLO® technology illuminates entire watch face at night and in low light conditions.

2.Continue to press up to 3 seconds to maintain illumina- tion.

3.Press and hold INDIGLO® button for 4 seconds to activate NIGHT-MODE® feature.

4.When NIGHT-MODE® feature is activated, push any button to illuminate watch face for 3 seconds.

5.To deactivate NIGHT-MODE® feature, press INDIGLO® button for 4 seconds. Feature will automatically deactivate.W

WATER & SHOCK RESISTANCE

If your watch is water-resistant, meter marking or (O) is indicated.

Water-Resistance Depth	p.s.i.a. * Water Pressure
	Below Surface
30m/98ft	60
50m/164ft	86
100m/328ft	160

*pounds per square inch absolute

WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS UNDER WATER.

1.Watch is water-resistant only as long as lens, push buttons and case remain intact.

2.Watch is not a diver watch and should not be used for diving.

3.Rinse watch with fresh water after exposure to salt water.

4.Shock-resistance will be indicated on watch face or case-

14 15