TOA Electronics C-CV44-3 NTSC Adjustment, Removing the sunshade Removing the front cover

6. ADJUSTMENT

1. Detach the sunshade and front cover after completing camera mounting and connections.

[Removing the sunshade] [Removing the front cover]

Loosen the two sunshade fixing screws.

Pull out the sunshade after rotating.

Turn the front cover in the direction indicated by the arrow to remove.

Front cover

2. Connect the Monitor output terminal to the monitor.

Note: The camera will not operate, even if this terminal is connected to the camera drive.

3.Switch on the power to the camera, permitting a picture to be viewed on the monitor.

4.Set the Mode setting switch for the best possible picture reproduction, depending on the installation conditions.

•Set the Shutter speed switch to the ON position when light flicker is an annoyance.

•Set the Backlight compensation switch to the ON position when a subject appears blacked-out. For more information on these switches, refer to p. 13; “About the Mode Switch.”

10