Manuals / Toshiba / Computer Equipment / Power Supply

Toshiba 1000 manual Model, Backup time Internal, Recharge time to 90%, batteries, capacity

Models: 1000

1 54

Page 28

Planning a UPS system should include the following considerations:

•The total demand of the protected system shall dictate the output power rating (VA). Allow a margin for future expansion or calculation inaccuracies from measuring power requirements.

•Backup time needed will determine the battery size needed. If the load is less than the UPS nominal power rating then the actual backup time will be longer.

•The following options are available:

•External Battery Cabinets, and

•Connectivity options (Remote Contact, SNMP/WEB card).

The following UPS models are available.

Model	Backup time Internal	Recharge time to 90%
Model	batteries	capacity
	batteries	capacity
UPS 1000VA	7 min	4 hours
UPS 1500VA	6 min	4 hours
UPS 2000VA	7 min	4 hours
UPS 3000VA	6 min	4 hours

Additional External Battery Cabinets are available if more back-up time is needed.

Page 28

Image 28

Toshiba 1000 manual Model, Backup time Internal, Recharge time to 90%, batteries, capacity

Contents

Page IMPORTANT NOTICE UNINTERRUPTIBLE POWER SYSTEM Table of Contents 5.4 EPO Port emergency power off 6.6 UPS Configurations6.9 Audible Alarms Silencing an AlarmManual’s Purpose and Scope Copyright 2006 Toshiba International Corporation. All rights reserved Page FCC Part EMC StatementsICES-003 Declaration of Conformity Request Signal Words General Safety InstructionsSafety Alert Symbol / Signal Words DANGERCAUTION / ATTENTION Special Symbols Qualified Personnel ONLY Important Safety InstructionsQualified Personnel shall DANGER Do not dispose of the batteries in a fire. The batteries may explodeTo be performed by Qualified Personnel only Instructions Importantes Concernant LA SÉCURITÉ CONSERVER CES INSTRUCTIONSInspection/Storage/Disposal InspectionUncrating StorageStorage Maintenance DisposalInstallation Precautions Conductor Routing and Grounding THE METAL OF CONDUIT IS NOT AN ACCEPTABLE GROUNDOperating Precautions XXII 1. Introduction 2. System Description2.1 General Description 2.2 Efficiency Optimizer Function 2.4 Diagnostic Tests 2.3 Free Run Mode2.5 System Configuration Backup time Internal ModelRecharge time to 90% batteries3. Storage 4. Installation 4.1 Environment4.2 Rear Panel Views 1000VA - 1500VA Tower Rear Panel 2000VA - 3000VA Tower Rear PanelBATTERY BATTERY1000 - 1500 VA Rack mount 2U Rear Panel 2000 - 3000 VA Rack mount 2U Rear PanelRM-2U 120VNEMA RM-2U230 VIEC RM-2U 120VNEMA RM-2U 230VIEC4.3 Connection to main supply and loads 1000 - 3000 VA Figure 2 Example of Installation of Plug & Play products 4.4 Front Panel Settings Listed below are the default settings of the primary UPS parameters7 OUTLET 5. Computer and Alarm Connections SignalTable 1 RS232 Pin Out Signal 5.1 RS-232 Standard Interface PortDB9 Male Connector Outline facing connector Table 2 DryContact Pin Out Signal Chart5.2 Dry Contact Interface optional card 5.3 USB Port5.5 Network Transient Protector 5.4 EPO Port emergency power off5.6 Load Segments 6. User’s Guide to Operations 6.1 UPS Startup and Shutdown Starting the UPSShutting Down the UPS 6.2 Button Operation6.3 Control Panel Functions Figure 3 Control panel 6.4 Normal Display6.5 UPS Meters Display LCD Message6.6 UPS Configurations 6.9 Audible Alarms 6.10 Silencing an Alarm6.7 UPS Manual Test 6.8 Interpreting UPS MessagesAlarm Description 6.11 TroubleshootingWhat You Should Do 7. Maintenance 8. Technical Specifications 8.1 Power Range 1000-3000 VA8.2 Power Range 1000-3000 VA RemotEye II and EMD9. Warranty Information TOSHIBA INTERNATIONAL CORPORATION LIMITED WARRANTY POLICYUNINTERRUPTIBLE POWER SYSTEM 48 contiguous U.S. States, Canada & MexicoLIMITATIONS AND EXCLUSIONS PROCEDURE MODIFICATIONSEnd User Model Number Serial Number Warranty End DateStartup Date