Toshiba TRR Page 9 7/02, Satellite
Satellite 1400 Series Disassembly Overview, cont.
To remove the modem daughter card (MDC), follow
the steps below.
1. Turn the computer upside down.
2. Remove one M2.5x4 black flat-head
screw.
3. Lift off the modem slot cover.
4. Remove two M2x4 super flat screws
securing the MDC.
5. Carefully lift up the MDC to disconnect it
from PJ9 (S1400) or PJ125 (S2400) on
the system board.
6. Carefully disconnect the modem cable
from JP1 on the MDC.
To remove the wireless LAN card, follow the steps
below.
1. Remove one M2.5x4 black flat-head
screw.
2. Lift off the Wireless LAN card slot cover.
3. Disconnect the Wireless LAN antenna
cables (black and white) from the
Wireless LAN card using an antenna
coaxial cable disconnector.
4. Push the Wireless LAN card lock
latches outward to release the card. It
will pop up to about a 45 degree angle.
5. Pull out the Wireless LAN card. Be
careful not to damage the connector.
To install the wireless LAN card (an option in some
models), follow the steps below.
CAUTION: Be sure to turn the computer off before
removing the card. Otherwise, the computer or the
card may be damaged.
1. Insert the Wireless LAN card into the
connector at an angle of 45 degrees.
2. Gently push the Wireless LAN card down
until latches on both sides engage to
hold it in place.
3. Connect the Wireless LAN antenna
(black and white) cables to the
connectors on the card.
CAUTION: Be sure the cables lie inside the guide.
Be careful not to damage or pinch the cables
when you seat the card.
4. Seat the Wireless LAN card slot cover.
5. Secure the cover with one M2.5x4 black
flat-head screw.
CAUTION: There are two MAC address barcode
labels in the package with the card. Apply one
labelo next to the Wireless LAN socket and one
on the box the computer was shipped in. Remove
old labels before applying the new ones. The
computer may have MAC address barcod labels
both wired and Wireless LANs. Be sure to replace
the correct label.