Personal Preferences (PP)

All the preset values will be restored, when pressing "PP" key.

After the setting time of sleep timer has passed then TV goes automatically to stand-by. ￿￿￿￿

Sound Indicator

The alternatives of the indicator are Mono, Stereo, Dual I and ual II. This indicator is displayed under the programme num- ber indicator on the screen. "I-II" key is used to select Mono or Stereo, or Dual I or Dual II.

In Mono broadcast or in forced-mono (for stereo broadcast)6WHUHR.

In Stereo broadcast'XDO. ￿￿￿,,

If dual broadcast detected. Dual I is se- lected in default and also can be select- ed after Dual II by Remote Control.

If Dual II selected ,￿￿by Remote Control.

Picture Mode

Picture mode OSD is displayed when

WIDE” key is pressed. Picture mode can be changed to Auto, 4:3, 16:9, Cine- ma, Subtitle, Zoom or Panorama by pressing “ WIDE” key.

Sleep Timer Indicator

It is displayed on the upper right of the screen when a new programme is en- tered by digit key or by pressing “P<P”, “-

P/CH“, “P/CH+“, “79/ DTV”, “” or “” key. If sleep timer is activated it is dis- played with the TV status and erased with it after 3 seconds.

Mute Indicator

It is placed in the upper middle of the screen when enabled, and it stays there until it is disabled.

To cancel mute, there is two alternative;

the first one is pressing to "" key, this volume is set to the preceding value, and the second one is increasing the volume level, thus it starts at the minimum level to increase. By decreasing the volume level in mute state, mute will not be ig- nored, only the volume level will de- crease. If mute canceled after decreas- ing the volume level, the volume will valid with the decreased level.

No-Signal Detection (TV)

If no valid signal detected, it takes 5 min- utes for the switching to the Stand-By mode unless any signal detected or no any Remote

Control command is accessed.

After a Remote Control command (if No- Signal Timer is active) the timer stops and if no signal detected again the timer is initialized to 5 minutes and starts 3 seconds later again to count down.

It is not valid in AV ￿￿￿￿mode.

No-Signal Detection (PC)

If no valid signal detected for 5 minutes system goes to Stand-By mode. To

switch on the system press “” key.

As the last status feature, system starts from TV or PC, whichever was the status before stand-by or switch-off. Note that SCART inputs have the precedence on both TV and PC.

51

50052932-1552UK (TOSHIBA UK)17 INCH TFT51-IDTV-WO WM-dilek p65

11 05 2004 15:30

Page 52
Image 52
Toshiba 17WLT46B owner manual Personal Preferences PP, Sound Indicator, Picture Mode, Sleep Timer Indicator, Mute Indicator