エラー
!
スタイルが定義されていません。
エラー
!
スタイルが定義されていません。
エラー
!
スタイルが定義されていません。
Replacement Procedures
エラー
!
ス
Installing the LCD unit
To install the LCD unit, follow the steps below and refer to Figure 4-51 to 4-54.
1. Set the brake hinges (left and right) to the LCD unit and secure them with the
following screws.
M2.03C S-THIN HEAD screw 8
NOTE: When securing the brake hinges, be sure to secure the screws in the order of the
number marked on the brake hinges.
2. Connect the LCD harness to the connector on the back of the LCD unit and stick the
tape in place.
3. Set the LCD unit to the LCD cover and fix the LCD harness with the insulator.
4. Secure the LCD unit with the following screws.
Be carful not to forget securing the drain wire.
M2.55B FLAT HEAD screw 8
CAUTION: Make sure that the LCD harness is not pinched between hinge and LCD
cover.
LCD harness
QOSMIO F60 Maintenance Manual (960-796) [CONFIDENTIAL] 4-87