エラー
!
スタイルが定義されていません。
エラー
!
スタイルが定義されていません。
エラー
!
スタイルが定義されていません。
Replacement Procedures
エラー
!
ス
Installing the LCD assembly/Base assembly
To install the LCD assembly/base assembly, follow the steps below and refer to Figure 4-28
and 4-29.
1. Place the LCD assembly to the base assembly and set the speakers into the slots.
NOTE: Stick the insulator (KENSINGTON INSULATOR) as shown in the figure below.
KENSINGTON
insulator
2. Secure the LCD assembly, base assembly and drain wire with the following screws.
Be carful not to forget securing the drain wire.
M2.56B FLAT HEAD screw 3
3. Turn up the insulator and arrange the LCD harness and speaker harness in place.
QOSMIO F60 Maintenance Manual (960-796) [CONFIDENTIAL] 4-49