Toshiba A135, A130 manual Adding memory optional, Removing/installing the bottom module

	Getting Started	51
	Adding memory (optional)
NOTE	If your system has the memory modules stacked on top of one
	another, you must remove the top module first before

removing/installing the bottom module.

11Pick up the memory module by its sides, avoiding any contact with its connector. Position the module toward the socket, aligning the connector’s notch with the matching key in the socket.

notch

latch

connector

latch

key

(Sample Illustration) Aligning the memory module with the socket

12Firmly press the memory module into the memory slot’s socket at approximately a 30-degree angle (to the horizontal surface of the computer).

(Sample Illustration) Inserting the memory module into the socket

13Once the module’s connector is fully inserted into the socket, press downward on the top edge of the module to seat the module into the latches at the sides of the socket. These latches should “snap” into place securely with the corresponding