Toshiba B-480-QP owner manual Loading the Ribbon

6. LOADING THE RIBBON

ENGLISH VERSION EO1-33007

6. LOADING THE RIBBON

6. LOADING THE RIBBON

WARNING:

1.Do not touch moving parts. To reduce the risk that fingers, jewelry, clothing, etc., be drawn into the moving parts, push the switch in the “OFF” position to stop movement.

2.To avoid injury, be careful not to catch or jam your fingers while opening or closing the cover.

There are two types of media available for printing on, these are standard media and direct thermal media (a chemically treated surface). DO NOT LOAD a ribbon when using a direct thermal media.

1.When using a narrow width ribbon, slide the ribbon stoppers along the shafts to a position where the ribbon will be centered when it is fitted. When changing from a narrow width to a wider one rotate the ribbon stoppers by 90 , push them back to the correct position and then rotate back to lock.

NOTE: When attaching the ribbon stoppers, fit them to the shafts with the pinchers facing into the printer.

Ribbon Stopper

Ribbon Stopper

Fig. 6-1

2.Leaving plenty of slack between the spools, fit the ribbon as shown below. When the ribbon is fitted it must be positioned over the ribbon sensor.

3.Wind both shafts towards each other to tighten the ribbon.

Ribbon Sensor

Ribbon Shafts

Ribbon

Ribbon

Fig. 6-2

4.Reset the ribbon shaft holder plate by aligning it with the ribbon shaft.

5.Turn the head lever clockwise to lower the print head.

6.Close the top cover.

E6-1