Toshiba BSA4TMTS12QMR, B-SA4TM-TS12-QM-R owner manual Control Code Selection

2. PRINTER SETUP

ENGLISH VERSION EO1-33047

2.7 Setting an Operating Environment

2.7.1Parameter Setting (Cont.)

When ON is selected, pressing the [PAUSE] key will result that the LCD Message Display shows the stop position fine adjustment value setting screen.

<2>PARAMETER SET POSITION +0.0mm

	POSITION +5.0mm
[RESTART]
	POSITION +0.0mm
[FEED]
	POSITION -5.0mm
[FEED] key:	Pressing the [FEED] key one time causes a –0.1mm change,

up to –5.0 mm.

[RESTART] key: Pressing the [RESTART] key one time causes a +0.1mm change, up to +5.0 mm.

After selecting an auto forward wait, press the [PAUSE] key.

(10) Control Code Selection

This parameter is to choose a Control Code.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET CODE AUTO

Use the [FEED] or [RESTART] key to select a desired option.

[RESTART]

[FEED]

CODE AUTO

CODE ESC,LF,NUL

CODE{}

CODE MANUAL

Automatic selection

Manual selection

Manual selection

Control codes should be specified.

When “CODE MANUAL” is selected and the [PAUSE] key is pressed, the LCD display will show the setting screen of CONTROL CODE1 to CONTROL CODE3 as follows.

<2>PARAMETER SET CONTROL CODE1 1B

		CONTROL CODE1 FF
[RESTART]		CONTROL CODE1 FE
		CONTROL CODE1 FD
	[FEED]	CONTROL CODE1 02
		CONTROL CODE1 01
		CONTROL CODE1 00

E2-22