Toshiba BSA4TMTS12QMR, B-SA4TM Keyboard Interface Selection, Strip Motor Torque Selection

2. PRINTER SETUP

ENGLISH VERSION EO1-33047

2.7 Setting an Operating Environment

2.7.1Parameter Setting (Cont.)

NOTE:

When the print tone is too light, turn up the print tone in the positive (+) direction first. If the print tone does not improve by the print tone fine adjustment, choose TONE TABLE TYPE 2. Please do not turn up the print tone excessively, as doing this may cause ribbon wrinkles.

(26) Keyboard Interface Selection

This parameter is to choose a keyboard interface.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET

KB I/F OFF

Use the [FEED] or [RESTART] key to select a desired option.

				Not used.
		KB I/F	OFF
[RESTART]
				KB-60 old version
		KB I/F	KB60(1)
				KB-60 current version
		KB I/F	KB60(2)
	[FEED]
				KB-80
		KB I/F	KB80

After selecting a keyboard interface, press the [PAUSE] key.

(27) Strip Motor Torque Selection

This parameter is to choose a strip motor torque.

When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET PEEL OFF TRQ R0

Use the [FEED] or [RESTART] key to select a desired option.

			R0: Low
		PEEL OFF TRQ R0
[RESTART]
			R1:
		PEEL OFF TRQ R1
			R2:
		PEEL OFF TRQ R2
	[FEED]
			R3: High
		PEEL OFF TRQ R3

After selecting a strip motor torque, press the [PAUSE] key.

(28) Print Head Applied Current Table Selection

This parameter is to choose the applied current level to the print head. When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.

<2>PARAMETER SET TONE TABLE TYPE1

Use the [FEED] or [RESTART] key to select a desired option.

		TONE TABLE	TYPE1	Standard table
[RESTART]
		TONE TABLE	TYPE2	Additional table 1
	[FEED]

After selecting the print head applied current table, press the [PAUSE] key.

E2-31