2. PRINTER SETUP ENGLISH VERSION EO1-33047
2.7 Setting an Operating Environment
E2-29
2.7.1 Parameter Setting
(Cont.)
(23) Pre-Strip Selection
This parameter is to choose whether to activate the Pre Strip function.
When this parameter is set to ON (Available), the top edge of a label is
separated (pre-stripped) from the backing paper before the label is printed.
This function is intended to make the strip issue easier in case the labels
are hard to strip due to the label intensity, adhesive power, or the printing
speed.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
When ON is selected, pressing the [PAUSE] key enables the adjustment
value setting.
After setting an adjustment value, press the [PAUSE] key to make a pre-
strip function test.
When the [FEED] key is pressed, the printer feeds a label.
If the label stops with its top edge aligning with the strip shaft edge, the
adjustment value has been properly set. Press the [PAUSE] key to go to
the next parameter setting.
If further adjustment is required, press the [RESTART] key to return to
the adjustment value setting.
<2>PARAMETER SET
PRE PEEL OFF OFF
PRE PEEL OFF OFF
PRE PEEL OFF ON
[RESTART]
[FEED]
Unavailable
Available
[RESTART]
[FEED]
P.P.FEED +9.9mm
P.P.FEED +9.8mm
P.P.FEED -2.4mm
P.P.FEED -2.5mm
P.P.FEED +9.7mm
P.P.FEED -2.3mm