Toshiba BSA4TMTS12QMR, B-SA4TM owner manual This parameter is to enable Dhcp, Dhcp Client ID

2. PRINTER SETUP

ENGLISH VERSION EO1-33047

2.7 Setting an Operating Environment

2.7.7IP Address Setting (TCP/IP) (Cont.)

NOTE:

Pressing the [PAUSE] key while “DHCP ON” is displayed allows you to set a DHCP client ID.

(5) DHCP

This parameter is to enable DHCP.

<7>IP ADDRESS DHCP

	[PAUSE]	[RESTART] or [FEED]
<7>IP ADDRESS			<7>IP ADDRESS
DHCP OFF			DHCP ON

NOTES:

1. Code used to enter a DHCP

client ID is selectable between

ASCII code (alphanumeric) and

Hex code.

[PAUSE]

<7>IP ADDRESS DHCP CLIENT ID

(6) DHCP Client ID

This parameter is to set a DHCP client ID.

<7>IP ADDRESS DHCP CLIENT ID

[PAUSE]

[FEED] or [RESTART]

2.	Set a character or value for
	each byte by using the
	[RESTART] or [FEED] key.
	[RESTART] key: Increment
	[FEED] key: Decrement
3.	Press the [PAUSE] key to enter
	the next byte. Repeat this until
	16th byte is entered.
4.	A DHCP ID can be used to

MODE ASCII

DHCP CLIENT ID

ASCII Code

[PAUSE]

MODE ASCII ABCDEFGHIJKLMNOP

MODE HEX

DHCP CLIENT ID

		Hex. Code
	[PAUSE]
4142434445464748
494A4B4C4D4E4F50

check what IP address is

assigned to which client on a

DHCP server. If a DHCP ID is

not assigned, MAC address of a

network device (LAN card or

LAN interface board) will be

notified to the server as a

DHCP ID instead.

A DHCP ID is a 16-byte

character string. As “FFH”

(hex. code) is recognized as a

terminator, if the top byte of

DHCP ID is “FFH”, it is

considered that a DHCP ID is

not assigned.

Enter a character or a value for each of 1st byte to 16th byte sequentially using the [FEED] or [RESTART] key.

[PAUSE] [PAUSE]

E2-43