Additional information

87
Load another disc for recording.
System error.
Please wait.

General

Error/Warning message list
ERROR/WARNING MESSAGE
CAUSE POSSIBLE SOLUTIONS

NOTE:Any error/warning message other than those above might appear. Take measures against such a mes-

sage by seeing the possible solutions above.

The power was shut down without com-
pleting the termination process due to a
power failure or disconnection of the AC
cord plug. (Abnormal termination)
The data restoration was completed.
A scratch or contamination was found on
the disc.
The disc cannot be identified.
A disc specified other than “Region 1” or
“Region ALL” was loaded.
Recording was tried onto the disc which
does not support recording.
• Adding data was tried onto the disc re
corded in the other unit.
• Adding data was tried to the disc where
PC data was recorded.
Wait until the message disappears.
Press ENTER, then the screen re-
turns to the normal display. The
data may not be restored even
if
the restoration process is performed.
Check the disc and reload it, or use
another disc for recording.
Check the disc and load a proper
disc.
A disc specified other than “Region
1” or “Region ALL” cannot be played
back.
Load a recordable disc.
99 titles were recorded on the disc.
Recording was attempted on a copy
protected video.
An invalid key pressed during timer re-
cording standby and recording.
Timer recording is standing by.
• A copy protected tape is used
• Disc protection is set.
The video tape or disc became full during
dubbing.
Erase unnecessary titles or load
another disc.
You cannot record a copy protected
video.
Wait until the timer recording is com-
plete.
Cancel the timer recording standby
mode.
Load another video tape or disc for
recording and restart.
Load another video tape or disc for
recording and restart.
A scratch or contamination was found on
the disc.
Check the disc and reload it, or use
another disc for recording.

Playback

Recording

Cannot record.
Disc protected.
Select “Off” to cancel the disc
protection from Setup Menu (DISC).
Or slide the protect switch to off on
the DVD-RAM cartridge itself.
Undo finalization or load another
disc for recording.
Cannot record.
Disc finalized.
Recording was tried onto the finalized
disc.
Wait until the process is completed.Data is being written to the
disc.
The recording termination is processing.
Erase unnecessary titles or load
another disc and restart recording.
Disc became full during recording.
No space on the disc.
Cannot record, exceeds
limited number of titles.
Cannot record.
Protected image.
The operation cannot be
executed during timer
recording standby and
recording.
Cancel T-REC standby after
executing this operation.
Unable to shift during
duplication process.
Duplication aborted.
Copying interrupted.

Dubbing

System error.
Disc might be failed.
Press ENTER.
Disc error.
Incorrect disc.
Cannot playback.
Region code error.
Cannot record.
Disc erase-protection is applied.
2H5-01 P82-87 7/25/05, 23:2387