Setting System Parameters

Night Transfer

Night Transfer

Incoming calls to your system can be made to route and ring different destinations, based on either two- or three-call routing (ringing) patterns (set in system programming). The Night Transfer LED indicates the active routing pattern:

Mode

Three-pattern

Two-pattern

DAY

OFF

OFF

 

 

 

DAY 2

FLASH

N/A

 

 

 

NIGHT

ON

ON

 

 

 

Night Transfer can be locked by pressing 17￿/RFN￿￿￿a￿￿ and dialing the NT Lock password (see the procedure outlined on the following page).

If the system has tenant service, up to four Tenant Night Transfer buttons (1LJKW￿ 7UDQVIHU￿￿a￿) can be assigned and controlled independently.

To enable/disable night transfer

Press 1LJKW￿7UDQVIHU to toggle night transfer ON/OFF.

Night Transfer Lock/Unlock Password

The Night (NT) Lock/Unlock mode enables the Administrator’s station or an attendant console to lock the system into the Day, Day 2, or Night mode. By setting the system into different modes, incoming CO calls can be routed to different destinations.

In order for the Administrator station or the attendant console to perform such routing, it must be assigned with 1LJKW￿7UDQVIHU and 17￿/RFN buttons via system programming. Up to four 1LJKW￿7UDQVIHU and 17￿/RFN￿buttons are allowed.

Check with the system installer for any additional information.

Strata DK System Administrator Guide 5/00

9

Page 19
Image 19
Toshiba DKA-AG-SYSTEMVD manual Night Transfer Lock/Unlock Password, To enable/disable night transfer