Toshiba DKT2304-CT manual Select Location, Place DKT3000-series Telephones into 2000-Mode

Installation

Step 2: Select Location

Step 2: Select Location

1.Select a location that is not subject to excessive heat or humidity. Keep the base unit and handset away from sources of electrical noise, such as motors and fluorescent lighting.

2.Determine if the base unit will sit on your desk or be wall mounted. If wall mounted, go to Step 6: “(Optional) Wall Installation” on page 19.

3.Place the base unit on a desk or tabletop near a standard 120VAC outlet and within reach of the Strata CTX digital line connection.

Important! Place the base unit to the right of the DKT. If placed on the left, the cordless antenna picks up a tone due to its close proximity to the DKT speaker and electronic parts.

Step 3: Place DKT3000-series Telephones into 2000-Mode

You must place your DKT3000-series telephone into 2000-mode before connecting the cordless telephone; otherwise, the 3000-series telephone will not work.

In 2000-mode, the DKT3000 telephone operation changes are:

•Only 16 characters by two lines display on the LCD.

•LCD Feature button does not work

•Spdial button does not work

➤To change DKT3000-series telephones into 2000-mode

1. On the DKT3000 telephone, press 3+6+9+Hold (simultaneously).

2. Press #.

3. Press FB7 (or FB10 on the DKT3014). LED On = 2000 mode. LED Off = 3000 mode.

Note Flexible Buttons (FB) are numbered from the bottom up and left to right. FB7 for example would be the seventh button up on the left.

4. Press Hold.

5. Lift the handset to exit programming mode. Wait a few seconds for the telephone to reset itself.

16 Strata CIX and CTX DKT2204-CT/DKT2304-CT Cordless Digital Telephones