Toshiba GD-1250, GD-1260, GD-1270, GD-1160, GD-1210 service manual Discard printing

1)Discard printing

-Since the trailing edge area of the original is normally blank, this blank area is cut off to allow the image fit in one sheet in this mode. Image reduction is not performed.

-Maximum discarding amount:

0 mm: Discard not performed

10 mm: Corresponding to the inside the TTI

18 mm: Corresponding to the outside the TTI 1

22 mm: Corresponding to the outside the TTI 2

34 mm: A4 → LT conversion

(TTI: Transmission Terminal Identifier)

When the discard function is ON (13–378:1):

Actual size recording is performed with no vertical reduction nor division. The original image is recorded as it is. Namely, the data exceeding the effective printing area are discarded.

A	A
B	A : Effective printing length
	B : Recording data length outside the
Area B is discarded.	effective printing area
	(A + B = Recording data length)

Fig. 2-1

Discard parameter (13-375: 0 to 4)

The following parameters are available:

Discard function	Length of B (Discard parameter)	Set value
OFF	0 mm	0
ON	10 mm	1
	18 mm	2
	22 mm	3
	34 mm	4

Reference: These parameters should be set by the service technician (in the FAX Function Mode).

2)Vertical reduction printing (13–377: 0)

-The recording data length is reduced so that the image fits in the recording paper.

The data can be reduced up to 90/75%, and the machine automatically selects the appropriate ratio.

GD-1210/1250/1270/1160/1260	© 2006 - 2011 TOSHIBA TEC CORPORATION All rights reserved
LSU-RELATED FUNCTIONS

2 - 4