Toshiba GD-1260, GD-1250, GD-1270, GD-1160, GD-1210 service manual Binary signals

(2)Binary signals

NSF	Non-Standard Facility
	Informs that the receiving station (machine) has a non-standard facility.
NSC	Non-Standard Facility Command
	Command to transmit using the non-standard facility which is selected corresponding to
	NSF (i.e., Polling etc.).
NSS	Non-Standard Facility Setup
	Command to transmit using the non-standard facility which is selected corresponding to
	NSF or NSC.
CSI	Called Subscriber Identification
	Provides the telephone number of the called station. Used to check the identity of the called
	station.
CIG	Calling Subscriber Identification
	Provides the telephone number of the calling station. Used to check the identity of the call-
	ing station (Polling, etc.).
TSI	Transmitting Station Identification
	Provides the telephone number of transmitting station. Used to check the identity of the
	transmitting station.
DIS	Digital Identification Signal
	Informs that the receiving station (machine) has a standard facility (G3/G2).
DTC	Digital Transmit Command
	Command to transmit using the standard facility which is selected corresponding to DIS
	(i.e., Polling, etc.).
DCS	Digital Command Signal
	Commands to transmit using the standard facility which is selected corresponding to DIS or
	DTC.
SUB	Sub-address
	Indicates that the FIF information is a sub-address in the domain on the call-in side.
SEP	Select Polling
	Indicates that the FIF information is a sub-address for the polling mode.
PWD	Password
	Indicates that the FIF information is a password for the polling mode in a reception.
	Indicates that the FIF information is a password for transmission in a transmission.
CFR	Confirmation of Reception
	Informs that the FAX is ready to receive data.
FTT	Failure to Train
	Informs that the TCF signal has not received correctly and requests the re-training.
EOM	End of Message
	Informs that the the 1st page has been transmitted and there is the next page; command to
	return to the beginning of the phase B.
MPS	Multi-page Signal
	Informs that the 1st page has been transmitted and there is the next page; command to
	return to the beginning of the phase C.
EOP	End of Procedure
	Informs that a document has been transmitted and there is no more pages.
MCF	Message Confirmation
	A reply to MPS, EOM or EOP; informing that image signals have been received correctly
	and the FAX is ready to receive data.
RTN	Retrain Negative
	Informs that a document has not been received correctly; requests for the retraining or
	phase synchronization to receive the next page.
GD-1210/1250/1270/1160/1260		© 2006 - 2011 TOSHIBA TEC CORPORATION All rights reserved
DIALING/COMMUNICATION CONTROL

3 - 8