4-2. Line lock Control
¥Matching the vertical synchronization with the power frequency is called the Line Lock.
¥To activate the line lock, set the LL switch to ON.
1 2 3 4
ON
OFF
LineLock
¥When two or more cameras are switched by the video switcher for viewing with a display monitor the vertical synchronization phase can be locked to the power frequency for a stable vertical synchronization.
Video Switcher | Display Monitor |
BNC Connector |
|
Camera 1
Connector
To 24V AC UL Listed
Class 2 power supply.
Camera 2
¥ When connecting to DC power supply, the Line Lock function is not activated.
Note:
¥The camera is synchronized to the power frequency of 60 ±1 Hz covering a normal fluctuation of the power frequency. However, the camera may not cover a large fluctuation caused from the power generated by a generator, etc.
¥It takes approximately 10 seconds or more until a stable synchronization is obtained after the power is turned on. This is normal, because several seconds are required to stabilize the camera against power noise.
¥Refer to section 7. "LINE LOCK PHASE" for adjustment instructions.
- 7 -
