7. 5 | Partial Read ............................................ | 32 |
( 1 ) | Partial Scanning OFF |
|
| (All pixels scanning) ................................ | 32 |
( 2 ) Partial Scanning ON ............................... | 32 | |
( 3 ) When Partial Scanning Mode is ON ....... | 33 | |
7. 6 | External Sync.......................................... | 34 |
( 1 ) | External sync signal polarity ................... | 34 |
( 2 ) | External sync frequency range ............... | 34 |
( 3 ) | Using the unit with external sync signal .. | 34 |
| (3. 1) H (horizontal) phase adjustment .. | 34 |
10.BEFORE MAKING A SERVICE CALL........... | 37 |
11.SPECIFICATIONS .......................................... | 37 |
12.EXTERNAL APPEARANCE DIAGRAM......... | 38 |
1. CAUTIONS ON USE AND INSTALLATION
•Handling the unit.
Do not drop, jolt, or vibrate, as this may result in damage to the unit and may cause problems.
Treat the camera cables carefully to prevent cable problems, such as breaks in the cable and loose connections.
•Install the camera in a location free from noise.
If the camera or the cables are located near power utility lines or a TV, etc. undesirable noise may appear on the screen. In such a case, try to change the location of the camera or the cable wiring. Con- sult with a service personnel, if the noise still appears after changing the location or the cable wiring.
•Operating ambient temperature and humidity.
Do not use the camera in places where temperature and humidity exceed the specifications. Picture quality will deteriorate and internal parts may be damaged.
Be particularly careful when using in places exposed to direct sunlight. When shooting in hot environ- ments, depending on the conditions of the object and the camera (for example when the gain is increased), noise in the form of vertical strips or white dots may occur. This is not a malfunction.
•When not using the camera for extended periods of time.
Switch the control unit off and disconnect the power supply.
•Avoid using or storing the camera in the follow- ing places:
Places filled with highly flammable and corrosive gas. Places near gasoline, benzene, or paint thinner. Places subject to strong vibration.
Places containing chemicals (such as pesticides), rubber or vinyl products for extended periods of time.
•Do not shoot intense light.
If there is an intense light at a location on the screen such as a spot light, a blooming and smearing may occur. When intense light enters, vertical stripes may appear on the screen. This is not a malfunction. Ghosts may occur when there is an intense light near the object. In this case, change the shooting angle.
•Moire
A moire pattern is an interference pattern generated when two repetitive line patterns overlap. This is not a malfunction. Eliminating the repetitive line patterns, or aligning the two patterns, will eliminate the moire.
•Handling of the protection cap.
Keep the protection cap away from children as they may pose a choking hazard. The protection cap protects the image sensing plane when the lens is removed from the camera head, do not discard.
•When cleaning the camera.
Unplug the power source before cleaning. Clean with a soft dry cloth only. Do not use chemicals or chemi- cally treated cloths. Chemicals may damage coatings and printed letters. When cleaning the lens, use lens cleaning paper.
2. COMPONENTS |
| |
(1) | Camera Control Unit ...................................................................................................................... | 1 |
(2) | Accessories |
|
| (a) Instruction manual .................................................................................................................. | 1 |
| (b) EMI core ................................................................................................................................. | 1 |
5