Connecting the Alarm Terminals
iConnecting the ALARM IN/OUT terminals
Alarm switch
To alarm in
To GND
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Warning |
| External |
| |||
| interface |
|
|
| ||
|
|
|
|
| ||
| To alarm out | |||||
|
|
|
| |||
| Alarm lamp or alarm buzzer | |||||
•When the alarm switch is ON, alarm recording starts. It is possible to confirm the warning from outside by connecting the switching input of external interface devices such as alarm lamp or alarm buzzer to the alarm output. Please do not use the alarm output for power source to any of external devices.
i Connecting alarm reset input
Alarm reset switch
To GND
To alarm reset
•When the alarm switch is ON, alarm recording starts. However, when a closure is applied across the ALARM RESET and GND terminals, the alarm record condition resets and the VCR returns to the original record mode it was in before the alarm condition occurred.
Note:
iWhen simultaneously connecting alarm input and alarm reset input, be sure to carefully check the voltage levels.
INTRODUCTION
PREPARATION
RECORDING | OPERATION |
PLAYBACK | OPERATION |
NOTICE
30
