Toshiba L43, W43 user manual Switch Type None, LNB Power

English

SETTING UP YOUR TV

s Press b to highlight Start Scan, and press OK.

The television will start to search for available DTV and/or ATV channels. The progress bar will indicate the scan status.

You must allow the television to complete the search.

Auto Tuning - Antenna
	Progress	Found
DTV Tune	4 %	0
ATV Tune	Waiting...	0
	Channel: 23

When the search is complete, the television will automatically select channel one.

The Auto Tuning screen will display the total number of services found.

T Press C / c to view the DTV (digital channel) or ATV (analogue channel) lists.

u Press B / b to move through the list to select a channel, and then press OK to view.

In ATV mode, some areas may receive duplicate stations. There may not be a clear picture or the signal may be weak, so the station order can be changed using ATV Manual Tuning.

REMEMBER: Press TV at any time to select between ATV and DTV modes.

NOTE: The time will be set automatically by transmission but can be advanced or decreased by using Local Time Setting in the DTV Settings screen.

v Select Next and press OK. The Satellite Settings screen will appear. From this window, you can add the satellites that you wish to tune and configure detailed settings for each one individually.

Select Switch Type and choose the correct switch configuration for your satellite dish from the settings None, ToneBurst, DiSEqC 2way, DiSEqC 4way or Single cable.

Satellite Settings
	Switch Type			None		None
	LNB Power			On		ToneBurst
		No.	Satellite	Dish	LNB	DiSEqC 2way
		1	Astra 19.2E	1	1	DiSEqC 4way
		2				Single Cable
		3
		4

Done

NOTE:

•None is being used when the satellite dish will control only one universal Low Noise Block (LNB) with a single satellite (e.g. Astra 19.2°). As a rule, most households use just one satellite.

•ToneBurst sends a 22 kHz signal. ToneBurst is only necessary for simple LNBs (not universal LNBs). The 22 kHz signal is needed for switching LNBs with multifeed signals as well as for changing between low- and high-band.

•DiSEqC 2way automatically switches between two LNBs, which receive different satellites at the same time (e.g. Astra 19.2° and Hotbird 13°).

•DiSEqC 4way automatically switches between up to four LNBs / satellites.

•Single cable is selection and control of plural Satellite antennas through the combined single antenna cable.

The setting LNB Power enables you to switch on or off the LNB's power supply by means of the TV. When your satellite dish consists of only one LNB, LNB Power should generally be activated (On).

When using more than two LNBs, it is recommendable to use external power supply for these.

Satellite Settings
	Switch Type			None
	LNB Power			On		On
	No.		Satellite	Dish	LNB	Off
		1	Astra 19.2E	1	1
2

3

4

Done

It is possible to select up to four satellites. Please note that the number of available LNBs and the adjustment of your satellite dish determines the number of satellites found. For example, it is not possible to receive more than one satellite if your dish is directed to a single satellite. For further information on satellite signal technology, please contact your local dealer.

18