|
|
| Appendix C |
X5 | Enable | Enable | OK, RING, NO CARRIER, ERROR, |
|
|
| NODIALTONE, BUSY, CONNECT |
<RATE>, RRING, NO BONGTONE, DELAYED, BLACKLISTED, REORDER, WARBLE, CALL WAITING DETECTED
Dial tone detect
Disabled: The modem dials a call regardless of whether it detects a dial tone.
Enabled: The modem dials only upon detection of a dial tone, and disconnects the call if the dial tone is not detected within 10 seconds.
Busy tone detect
| Disabled: The modem ignores any busy tones it receives. | |
| Enabled: | The modem monitors for busy tones. |
| Result Codes: | |
| OK | n=0,1,2,3,4,5 |
| ERROR Otherwise | |
Zn | Recall stored profile | |
| The modem performs a soft reset and restores (recalls) the configuration | |
| profile according to the parameter supplied. If no parameter is specified, | |
| zero is assumed. Either Z0 or Z1 restores the profile. | |
| Result Codes: | |
| OK | n=0,1 |
| ERROR Otherwise | |
&Cn | Data Carrier Detect (DCD) control | |
| Data Carrier Detect is a signal from the modem to the computer indicat- | |
| ing that a carrier signal is being received from a remote modem. DCD | |
| normally turns off when the modem no longer detects the carrier signal. | |
&C0 The state of the carrier from the remote modem is ignored. DCD circuit is always on.
C PPENDIXA