Manuals / Brands / Computer Equipment / Personal Computer / Toshiba / Computer Equipment / Personal Computer

Toshiba M30 NOTES:, CAUTION:, Indicator, Disk-In-Use, Disk-In-Use, Disketteslot

1 236

Download 236 pages, 1.45 Mb

THE GRAND TOUR

User's Manual

USB diskette drive

A 3 1/2" diskette drive accommodates 1.44-megabyte or 720-kilobyte diskettes. It connects to the USB port.

DISK-IN-USE

INDICATOR

DISKETTE SLOT

EJECT BUTTON

Figure 2-10 USB diskette drive

Disk-In-UseThis indicator lights when the diskette is being accessed.

Indicator

Disketteslot Insert diskettes in this slot.

Eject button When a diskette is fully seated in the drive, the eject button pops out. To remove a diskette, push in the eject button and the diskette pops out partially for removal.

CAUTION: Check the Disk-In-Useindicator when you use the diskette drive. Do not press the eject button, turn off the computer or connect/ disconnect another USB device, while the light is glowing. Doing so could destroy data and damage the diskette or the drive.

NOTES: 1. The external diskette drive should be placed on a flat, horizontal surface when in use. Do not set the drive on an incline greater than 20o while it is operating.

2. Do not set anything on top of the diskette drive.

2-12

Contents

TOSHIBA Satellite M30 Series Portable Personal Computer User’s Manual Page Product Name : Satellite M30 Satellite M30 Model number : PSM30 PSM30 FCC notice "Declaration of Conformity Information FCC conditions Contact Address: Telephone: Conformity Statement Network Compatibility Statement Region selection Redial Pursuant to FCC CFR 47, Part 68: Type of service Telephone company procedures If problems arise Disconnection Fax branding Instructions for IC CS-03certified equipment NOTICE: Modem warning notice for Australia Notes for use of this device in New Zealand Page General conditions Panasonic UJDA750 Location of the required label TOSHIBA SD-R6012 Panasonic UJ-811 TEAC DV-W22E International precautions ADVARSEL: OBS VORSICHT: Table of Contents Chapter 3 Getting Started Chapter 4 Operating Basics Page Chapter 5 The Keyboard Chapter 6 Power Chapter 7 HW Setup Chapter 8 Optional Devices Chapter 9 Troubleshooting Appendixes Appendix A A-1 Appendix B B-1 Preface Conventions Abbreviations Icons Keys User's Manual Key operation ABC Display ABC General Precautions PC card overheating Mobile phone Central Processing Unit (CPU) Performance Disclaimer Introduction Processor Memory Power Disks Display Keyboard Pointing device Ports Slots Multimedia Communications Security Software Special features Page Utilities Page The Grand Tour Infrared port (Infrared model only) Volume control Wireless Right side Parallel port PC card slot S-Video out port Headphone jack Optical media drive Universal Serial Bus Back side LAN jack LAN active indicator (orange) Link indicator Memory module cover Battery release latch Battery safety lock Front with the display open TOSHIBA CONSOLE Display hinge Display screen Stereo speakers Microphone Power button System indicators CD/DVD Digital Audio Standby Shut Down Windows Disk Wireless Communication switch Communication switch CapsLock Arrow mode Numeric mode Disk-In-Use Indicator Disketteslot NOTES: CDs DVDs DVD-Rwrite CD-Rwrite CD-RWwrite DVD-RWwrite DVD-RAMwrite Page Getting Started General conditions Placement of the computer Setting up your work space Seating and posture Lighting Work habits Connecting the universal AC adaptor Page Windows End User License Agreement Shut Down mode (Boot mode) Benefits of hibernation Starting Hibernation Automatic Hibernation Data save in hibernation mode Benefits of standby Executing standby Standby limitations Operating Basics Connecting 3 1/2" diskette drive Disconnecting 3 1/2" diskette drive Safety Remove Hardware 3.ClickDiskette drive Loading discs Page Page Using optical disc drives Removing discs Mode Control button Controls for CD/DVD and Digital Audio CD/DVD control Digital Audio control Power is off Audio/Video controls Youpress for three seconds Next and Previous buttons Volume control Microphone level Audio controller Power management Advanced 2.Select the Enable Power Management check box 3.Input a time in Time to Power Saving State Enable Power Management Feedback Writing CDs on CD-RW/DVD-ROMdrive Important message Writing CD/DVDs on DVD Multi drive Important message Read/write function chart Manual User's DVD-R: DVD Specifications for Recordable Disc for General Version DVD-RW: DVD Specifications for Re-recordableDisc for Version DVD-RAM: DVD Specifications for DVD-RAMDisc for Version 2.0 or Version Page Drag’n Drop CD+DVD Page Data verification Data BOX DATA DISC Option Record and Verify Byte compare CD/DVDs Diskettes Region selection Setting Modem Selection Dialing Properties Supported features Wireless LAN Security Wireless communication switch Wireless communication indicator Indicator status Connecting LAN cable LAN Disconnecting LAN cable LAN Active Page Heat dispersal Maximum Performance Battery optimized Page The Keyboard Emulating keys on enhanced keyboard Soft keys: Fn key combinations Fn + F10 Fn + F11 ScrLock Sound mute: Esc Power save mode: Standby: Display selection: LCD Wireless setting: Fn + F8 are not used Touch Pad: Fn Sticky key F number TOSHIBA Arrow mode Numeric mode Generating ASCII characters Temporarily using overlay (overlay off) Temporarily changing modes Page Power Battery, DC IN Battery indicator Battery types DC IN indicator Power indicator Battery pack Real Time Clock battery 0250: RTC battery is low 0251: CMOS checksum is inconsistent Danger Warning Caution Note Procedures Time Battery charging notice Maximizing battery operating time Retaining data with power off Extending battery life Removing the battery pack Replacing the battery pack Installing the battery pack User password User Password User Token Start −> All Programs −> TOSHIBA −> Utilities −> Password Utility User Password field User Token field ❖Disable (button) Supervisor password Run 3.Enter the following: C:\Program Files\Toshiba\Windows Utilities\SVPWTool\TOSPU.EXE Power-upmodes Windows utilities HW Setup Setup Default About Parallel Port Mode Power On Display Boot Priority Options list Temporarily changing the priority Built-inLAN disabled Network Boot Protocol Wake-upon Keyboard Dynamic CPU Frequency Mode Wake-upon LAN Built-inLAN Page Optional Devices Cards/memory Power devices Peripheral devices Other Inserting a PC card PC cards Removing a PC card PC card Inserting an SD card SD cards Removing an SD card SD card care Page Memory expansion Installing memory module Removing memory module Universal AC adaptor Fn + F5 Connecting a TV Parallel printer a.Click start and click Control Panel Display Settings Device Selection Parallel/Printer TOSHIBA HW Setup 10.Set the Parallel Port Mode and press OK Reboot Add Print Wizard i.LINK (IEEE1394) 2.Point to i.LINK (IEEE1394) device and click Page Troubleshooting Analyzing the problem Software Hardware and system checklist Hardware System start-up Self test In Touch with Tomorrow TOSHIBA Power Overheating power down AC power Battery RTC Battery LCD panel Hard disk drive Page Page Page Page Page Diskette drive SD card PC card Infrared port Touch Pad USB mouse USB Memory expansion Sound system Monitor Modem CONNECT NO CARRIER Wireless LAN TV output signal NOTE: Printer TOSHIBA support i.LINK (IEEE1394) Add Hardware Before you call Where to write OutsideofEurope Australia Canada China Specifications Physical Dimensions Environmental Requirements Power Requirements Built-inModem Display Controller and Modes B-2 B-3 B-4 B-5 B-6 AT Commands +++Escape sequence Repeat last command A Answer command Bn Communication standard setting Dn Dial En Echo command Hn Hook control Request ID information Ln Monitor speaker volume Mn Monitor speaker mode Nn Modulation handshake On Return online to data mode P Select pulse dialing Qn Result code control T Select tone dialing Vn DCE response format Xn Result code selection, call progress monitoring Dial tone detect Busy tone detect Recall stored profile &Cn Data Carrier Detect (DCD) control &Dn DTR control &F Load factory settings &Gn V.22bis guard tone control &Kn Local flow control selection &Pn Select Pulse Dial Make/Break Ratio (WW) &Tn Self-testcommands Display Current Configuration Store current configuration &Zn=x Store telephone number \Nn Error control mode selection \Qn Local flow control selection \Vn Protocol result code % B View numbers in blacklist %Cn Data compression control S-registers S0 Auto answer ring number S1 Ring counter S2 AT escape character (user defined) S3 Command line termination character (user defined) S4 Response formatting character (user defined) S5 Command line editing character (user defined) S6 Wait before dialing S7 Connection completion time-out S8 Comma pause time S11 DTMF dialing speed S12 Escape guard time S37 Dial line rate The result code summary Result Code Description D-6 D-7 D-8 Appendix E Function Transmission speed E-2 Appendix E E-3 E-4 Internal Modem Guide F-2 Wireless LAN Supported frequency sub-bands Wireless IEEE 802.11 Channels Sets (Revision B/G) 2457 *1 G-2 Appendix G Wireless IEEE 802.11 Channels Sets (Revision A) G-3 Wireless Channels Sets (Turbo Mode) G-4 AC Power Cord and Connectors USA and Canada Australia Europe Parts Numbers ManualI PPENDIXUser'sA Glossary Abbreviations adaptor (Abbreviationscontinued) ROM: RTC: SCSI: cache memory asynchronous: backup: batch file: binary: capacity capacity: card: CardBus: character: dialog box control keys: controller: co-processor: CPS: disk drive disk drive: disk storage: diskette: display: hardware execute: fast infrared: file: firmware: hertz hertz: hexadecimal: host computer: hotkey: monitor keyboard: main board: See motherboard megabyte (MB): A unit of data megahertz: motherboard motherboard: MP3: online state: output: prompt parity: password: pel: peripheralcomponentinterconnect: Radio frequency interference (RFI) shield Radio frequency interference (RFI) shield: RandomAccessMemory(RAM): restart: write protection subpixel: synchronous: system disk: terminal: Glossary-14 Index User's manual Index-2 Index Index-3 Index-4 Index-5