Power and Power-Up Modes

Battery charging noticeThe battery may not charge right away under the following conditions:

■The battery is extremely hot or cold. If the battery is extremely hot, it might not charge at all. To ensure the battery charges to its full capacity, charge the battery at room temperature of 10° to 30°C (50° to 88°F).

■The battery is nearly completely discharged. Leave the AC adaptor connected for a few minutes and the battery should begin charging.

The Battery indicator may show a rapid decrease in battery operating time when you try to charge a battery under the following conditions:

■The battery has not been used for a long time.

■The battery has completely discharged and been left in the computer for a long time.

■A cool battery is installed in a warm computer.In such case, follow the steps below.

1.Fully discharge the battery by leaving it in the computer with the power on until the power automatically shuts off.

2.Connect the AC adaptor to the DC IN 15V jack of the computer, and the AC adaptor into power outlet.

3.Charge the battery until the Battery indicator glows green.

Repeat these steps two or three times until the battery recovers normal capacity.

Leaving the AC adaptor connected will shorten battery life. At least once a month, run the computer on battery power until the battery is fully discharged, then recharge the battery.

Monitoring battery capacityRemaining battery power can be monitored in TOSHIBA Power Saver.

■Wait at least 16 seconds after turning on the computer before trying to monitor the remaining operating time. The computer needs this time to check the battery’s remaining capacity and to calculate the remaining operating time, based on the current power consumption rate and remaining battery capacity. The actual remaining operating time may differ slightly from the calculated time.

■With repeated discharges and recharges, the battery’s capacity will gradually decrease. Therefore, an often used, older battery will not operate for as long as a new battery even when both are fully charged. In this case, TOSHIBA Power Saver will indicate a 100% charge for both the old and new battery, but the displayed estimated time remaining will be shorter for the older battery.

User’s Manual

6-9